I remove the glaze from the base of the vase by rubbing it on a wet cloth held flat on the table.Īfter the glaze is fully dry, I fire it to 1250 C, at a ramp-up rate of 6.5 C/min (about three hours), and let it cool at 20 C /min or the kiln’s natural cooldown rate, whichever is slower. I think the glaze could be a little thicker as well the 1:1 ratio might be too much water. It seems 3-4 total coats works best for a nice silky smooth finish. After fully dry, I dip again, this time hanging it in a different orientation to let the glaze flow all over the piece. I dip the part, and let dry by hanging it on a wire hook. I’m using Amaco Celebration high-fire glaze, and add equal volumes of glaze and water to a dipping container. The part is “bisque fired” and more delicate, but also more porous, which allows it to soak up the glaze. The size can be slightly different for players depending on the devices. Whats the download size of Lets Create Pottery Lite Lets Create Pottery Lite takes up 41.2 MB of data on mobile. I use the Formlabs recommended ramp and hold times, but change the maximum temperature down to 1040 C. Pottery Lite is free to download for Android devices, but it may contain in-app purchases. I use coarse sandpaper on a piece of glass to remove the support nubs from the base of the vase and leave a flat surface. Standard cleaning with IPA, and let air-dry. Tapping with a hammer works much better than any other technique I’ve tried. The base is almost completely covered with supports – almost solid!Īfter printing, I clamp the build plate in a bench vise and carefully chip off the support blob with a end-cutting xacto blade (tiny chisel). I use the recommended support size and density, and then remove all supports on the walls of the vase using the box selection tool. This will create a big airlocking problem, so I add a 2mm hole in the wall of the vase in the. For vases, and similar shapes, I print with the base of the vase parallel to the build plate, with the open end facing the tank of resin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |